Subaru Legacy

Since 1990-1998 of release

Repair and car operation



Subaru Legasi
+ 1.1. Identification numbers
+ 2. Maintenance service
+ 3. Engines
+ 4. Heating, ventilation
+ 5. Fuel system
+ 6. An exhaust system
+ 7. Systems of start, ignition
+ 8. Transmissions
+ 9. Coupling, shaft
- 10. Brake system
   10.1. Introduction
   10.2. Technical characteristics
   10.3. Replacement brake колодок on disk brakes
   10.4. A support of disk brakes
   10.5. A brake disk
   10.6. Replacement brake колодок drum-type brakes
   10.7. The working brake cylinder
   10.8. The main brake cylinder
   10.9. Brake pipelines and hoses
   10.10. Replacement of a regulator of pressure
   10.11. Prorolling of hydraulic brake system
   10.12. Adjustment of a manual brake
   10.13. Replacement of a cable of a manual brake
   10.14. Replacement brake колодок a manual brake on back disk brakes
   10.15. Additional brake system
   10.16. The vacuum amplifier of brakes
   10.17. The stoplight switch
   10.18. Antiblocking system of brakes (ABS)
+ 11. A suspension bracket
+ 12. A steering
+ 13. A body
+ 14. An electric equipment





10.13. Replacement of a cable of a manual brake
THE GENERAL DATA

Arrangement of cables of a manual brake


Arrangement of elements of fastening of a cable of a manual brake under the car


Arrangement of a bolt of fastening of a cable of a manual brake to a back suspension bracket of the car


PERFORMANCE ORDER
1. Remove the central console.
2. Unscrew a counternut and an adjusting nut from the end of a cable of a manual brake.
3. Lift a back part of the car and fix on supports. Remove back wheels.
4. Under the car unscrew bolts of all fastenings of a cable of a manual brake (fig. the Arrangement of cables of a manual brake, the Arrangement of elements of fastening of a cable of a manual brake under the car, the Arrangement of a bolt of fastening of a cable of a manual brake to a back suspension bracket of the car see).
5. Disconnect forward parts of back cables of a manual brake from the jack. Unscrew two nuts and remove an arm.
6. On models with drum-type brakes remove brake колодки and disconnect a cable of a manual brake from the lever on brake колодке.
7. On models with back disk brakes remove brake колодки a manual brake and disconnect a cable of a manual brake from the lever on back brake колодке.
8. Take fixing скобу fastenings of a cover of a cable of a manual brake to a brake board.
9. Take a cable of a manual brake from a brake board.
10. Installation is made in sequence, return to removal.
11. Check up smoothness of moving and adjust a cable of a manual brake.
12. Establish the central console.