Subaru Legacy

Since 1990-1998 of release

Repair and car operation



Subaru Legasi
+ 1.1. Identification numbers
+ 2. Maintenance service
+ 3. Engines
+ 4. Heating, ventilation
+ 5. Fuel system
+ 6. An exhaust system
+ 7. Systems of start, ignition
+ 8. Transmissions
+ 9. Coupling, shaft
- 10. Brake system
   10.1. Introduction
   10.2. Technical characteristics
   10.3. Replacement brake колодок on disk brakes
   10.4. A support of disk brakes
   10.5. A brake disk
   10.6. Replacement brake колодок drum-type brakes
   10.7. The working brake cylinder
   10.8. The main brake cylinder
   10.9. Brake pipelines and hoses
   10.10. Replacement of a regulator of pressure
   10.11. Prorolling of hydraulic brake system
   10.12. Adjustment of a manual brake
   10.13. Replacement of a cable of a manual brake
   10.14. Replacement brake колодок a manual brake on back disk brakes
   10.15. Additional brake system
   10.16. The vacuum amplifier of brakes
   10.17. The stoplight switch
   10.18. Antiblocking system of brakes (ABS)
+ 11. A suspension bracket
+ 12. A steering
+ 13. A body
+ 14. An electric equipment





10.15. Additional brake system
THE GENERAL DATA

Elements of additional brake system

1 – the brake valve
2 – a brake cable
3 – an adjusting nut of a cable
4 – a counternut
5 – plugs
6 – a pin
7 – шплинт
8 – U-shaped скоба
9 – a cable arm
10 – bolts
11 – скоба cable fastenings

Adjustment

PERFORMANCE ORDER
1. Check up and if necessary adjust a coupling cable.
2. Establish the car on road with a bias not less than 3 .
3. Slowly moving on road with a bias, stop the car and press only a coupling pedal. If the car starts to slide, the cable of additional brake system прослаблен means.
4. Moving an adjusting nut, adjust a cable tension.
5. Repeat check of work of additional brake system, having stopped the car on a bias and having pressed a coupling pedal. If necessary repeat adjustment. Do not draw a cable of additional brake system.