Subaru Legacy

Since 1990-1998 of release

Repair and car operation



Subaru Legasi
+ 1.1. Identification numbers
+ 2. Maintenance service
+ 3. Engines
+ 4. Heating, ventilation
+ 5. Fuel system
+ 6. An exhaust system
+ 7. Systems of start, ignition
+ 8. Transmissions
+ 9. Coupling, shaft
- 10. Brake system
   10.1. Introduction
   10.2. Technical characteristics
   10.3. Replacement brake колодок on disk brakes
   10.4. A support of disk brakes
   10.5. A brake disk
   10.6. Replacement brake колодок drum-type brakes
   10.7. The working brake cylinder
   10.8. The main brake cylinder
   10.9. Brake pipelines and hoses
   10.10. Replacement of a regulator of pressure
   10.11. Prorolling of hydraulic brake system
   10.12. Adjustment of a manual brake
   10.13. Replacement of a cable of a manual brake
   10.14. Replacement brake колодок a manual brake on back disk brakes
   10.15. Additional brake system
   10.16. The vacuum amplifier of brakes
   10.17. The stoplight switch
   10.18. Antiblocking system of brakes (ABS)
+ 11. A suspension bracket
+ 12. A steering
+ 13. A body
+ 14. An electric equipment





10.16. The vacuum amplifier of brakes

Check

PERFORMANCE ORDER
1. Press a brake pedal some times at the idle engine to create in cavities of the vacuum amplifier the identical pressure close to the atmospheric.
2. Simultaneously on the effort put to a pedal, define, whether there is no jamming of the case of the valve.
3. Stop a pedal of a brake in the middle of its course and start the engine. At the serviceable vacuum amplifier the pedal of a brake after engine start should leave forward.
4. If the pedal does not leave forward, check up fastening of a tip of a hose, a condition of fastening of a flange of a tip in the amplifier, a hose and union condition.

Removal

PERFORMANCE ORDER
1. Disconnect a vacuum hose from the vacuum amplifier of brakes.
2. Remove the main brake cylinder.
3. In car salon disconnect a pusher of the vacuum amplifier of brakes from the top part of a pedal of a brake.
4. Unscrew 4 nuts of fastening and take the vacuum amplifier of brakes from a motor compartment.

Installation

PERFORMANCE ORDER
1. Installation is made in sequence, return to removal.
2. At installation of the new vacuum amplifier of brakes check up distance from an axis of a pusher to the case of the vacuum amplifier of brakes (L).
3. For size adjustment выступания a pusher from the vacuum amplifier of brakes ослабьте a counternut and, rotating a pusher, establish a pusher axis on the demanded distance from the case of the vacuum amplifier of brakes.
4. Remove air from hydraulic system of brakes.