Subaru Legacy

Since 1990-1998 of release

Repair and car operation



Subaru Legasi
+ 1.1. Identification numbers
+ 2. Maintenance service
+ 3. Engines
+ 4. Heating, ventilation
+ 5. Fuel system
+ 6. An exhaust system
+ 7. Systems of start, ignition
+ 8. Transmissions
+ 9. Coupling, shaft
- 10. Brake system
   10.1. Introduction
   10.2. Technical characteristics
   10.3. Replacement brake колодок on disk brakes
   10.4. A support of disk brakes
   10.5. A brake disk
   10.6. Replacement brake колодок drum-type brakes
   10.7. The working brake cylinder
   10.8. The main brake cylinder
   10.9. Brake pipelines and hoses
   10.10. Replacement of a regulator of pressure
   10.11. Prorolling of hydraulic brake system
   10.12. Adjustment of a manual brake
   10.13. Replacement of a cable of a manual brake
   10.14. Replacement brake колодок a manual brake on back disk brakes
   10.15. Additional brake system
   10.16. The vacuum amplifier of brakes
   10.17. The stoplight switch
   10.18. Antiblocking system of brakes (ABS)
+ 11. A suspension bracket
+ 12. A steering
+ 13. A body
+ 14. An electric equipment





10.17. The stoplight switch
THE GENERAL DATA

Arrangement of the switch of a stoplight

The stoplight switch is fixed on an arm in the top part of a pedal of a brake.

Position of a pedal of a brake at free wheeling adjustment

1 – the stoplight switch

2 – a free wheeling of a pedal of a brake

3 – a full speed of a pedal of a brake

4 – distance from the pressed pedal of a brake to a floor

5 – a carpet covering of a floor

6 – a partition of a motor compartment

Check

PERFORMANCE ORDER
1. Disconnect from the stoplight switch an electric socket and to switch contacts connect an ohmmeter.
2. Check up that at the released pedal of a brake contacts of the switch of a stoplight are opened, and by pressing of a pedal of a brake switch contacts become isolated.

Adjustment

PERFORMANCE ORDER
1. Check up height of installation and a free wheeling of a pedal of a brake.
2. For adjustment of height of a pedal of a brake disconnect from the stoplight switch an electric socket, ослабьте a counternut of fastening of the switch and, rotating the switch, establish height of a pedal of a brake (the height of installation of a pedal of a brake is measured from a partition of a motor compartment).
3. Connect to the stoplight switch an electric socket and check up switch work.
4. For adjustment of a free wheeling of a pedal of a brake ослабьте a counternut on a pusher of a brake and, rotating a pusher, establish a demanded free wheeling then tighten a counternut (see fig. Position of a pedal of a brake at free wheeling adjustment).
5. For adjustment of position of the switch of a stoplight ослабьте a counternut of the switch and, turning the switch, adjust its position so that плунжер acted from the switch on 1–3 mm. Tighten a counternut.

Replacement

PERFORMANCE ORDER
1. Disconnect from the stoplight switch an electric socket.
2. Unscrew a counternut of the switch and unscrew the switch from an arm.
3. Installation is made in sequence, return to removal. If necessary adjust position of the switch of a stoplight.