Subaru Legacy

Since 1990-1998 of release

Repair and car operation



Subaru Legasi
+ 1.1. Identification numbers
+ 2. Maintenance service
+ 3. Engines
+ 4. Heating, ventilation
+ 5. Fuel system
+ 6. An exhaust system
+ 7. Systems of start, ignition
+ 8. Transmissions
+ 9. Coupling, shaft
- 10. Brake system
   10.1. Introduction
   10.2. Technical characteristics
   10.3. Replacement brake колодок on disk brakes
   10.4. A support of disk brakes
   10.5. A brake disk
   10.6. Replacement brake колодок drum-type brakes
   10.7. The working brake cylinder
   10.8. The main brake cylinder
   10.9. Brake pipelines and hoses
   10.10. Replacement of a regulator of pressure
   10.11. Prorolling of hydraulic brake system
   10.12. Adjustment of a manual brake
   10.13. Replacement of a cable of a manual brake
   10.14. Replacement brake колодок a manual brake on back disk brakes
   10.15. Additional brake system
   10.16. The vacuum amplifier of brakes
   10.17. The stoplight switch
   10.18. Antiblocking system of brakes (ABS)
+ 11. A suspension bracket
+ 12. A steering
+ 13. A body
+ 14. An electric equipment





10.7. The working brake cylinder

Removal

PERFORMANCE ORDER
1. Lift a back part of the car and fix on supports.
2. Remove a brake drum.
3. Remove a dirt round a place of connection of a brake tube and a back part of the working brake cylinder.
4. Unscrew a connecting nut.
5. Unscrew two bolts of fastening of the working brake cylinder to a brake board.
6. Being careful, remove the working brake cylinder. For reduction of losses of a brake liquid close a stopper the brake pipeline.

Installation

PERFORMANCE ORDER
1. Wipe a brake board, establish the brake pipeline on the brake cylinder and screw up a connecting nut on two turns.
2. Screw in bolts of fastening of the working brake cylinder. Definitively tighten a nut of fastening of the brake pipeline.
3. Establish a brake drum.
4. Remove air from brake system.