Subaru Legacy

Since 1990-1998 of release

Repair and car operation



Subaru Legasi
+ 1.1. Identification numbers
+ 2. Maintenance service
+ 3. Engines
+ 4. Heating, ventilation
+ 5. Fuel system
+ 6. An exhaust system
+ 7. Systems of start, ignition
+ 8. Transmissions
+ 9. Coupling, shaft
- 10. Brake system
   10.1. Introduction
   10.2. Technical characteristics
   10.3. Replacement brake колодок on disk brakes
   10.4. A support of disk brakes
   10.5. A brake disk
   10.6. Replacement brake колодок drum-type brakes
   10.7. The working brake cylinder
   10.8. The main brake cylinder
   10.9. Brake pipelines and hoses
   10.10. Replacement of a regulator of pressure
   10.11. Prorolling of hydraulic brake system
   10.12. Adjustment of a manual brake
   10.13. Replacement of a cable of a manual brake
   10.14. Replacement brake колодок a manual brake on back disk brakes
   10.15. Additional brake system
   10.16. The vacuum amplifier of brakes
   10.17. The stoplight switch
   10.18. Antiblocking system of brakes (ABS)
+ 11. A suspension bracket
+ 12. A steering
+ 13. A body
+ 14. An electric equipment





10.9. Brake pipelines and hoses
THE GENERAL DATA

Brake tubes and hoses are applied to transfer of a brake liquid from the main brake cylinder to working brake cylinders. Connections of tubes both brake cylinders and switching centres it is made конусными муфтами. The ends of tubes are pressed out and have the cone-shaped form for the corresponding size конусных carving apertures in brake cylinders or switching centres.

Before обжатием the ends of tubes the lock nut which after ввинчивания a cone-shaped surface in конусное the basis of a carving aperture presses and герметизирует a tube is put on them.

Brake hoses carry out mobile communications between mobile and motionless parts of the car.

PERFORMANCE ORDER
1. At unscrewing of brake hoses it is necessary to use накидной a wrench.
2. Before removal of a brake hose from a supporting arm, remove U-shaped скобу.
3. Remove a brake hose from a supporting arm.
4. For reduction of losses of a brake liquid at removal of working brake cylinders use clips for пережатия brake hoses.