Subaru Legacy

Since 1990-1998 of release

Repair and car operation



Subaru Legasi
+ 1.1. Identification numbers
+ 2. Maintenance service
+ 3. Engines
+ 4. Heating, ventilation
+ 5. Fuel system
+ 6. An exhaust system
+ 7. Systems of start, ignition
+ 8. Transmissions
+ 9. Coupling, shaft
+ 10. Brake system
+ 11. A suspension bracket
- 12. A steering
   12.1. Introduction
   12.2. Technical characteristics
   12.3. A steering wheel
   12.4. Tips of steering draught
   12.5. Replacement of protective covers of steering transfer
   12.6. Steering transfer
   12.7. The pump of the amplifier of a steering
   12.8. Removal of air from system of a steering with the amplifier
+ 13. A body
+ 14. An electric equipment





12.4. Tips of steering draught

Removal

PERFORMANCE ORDER
1. Lift a forward part of the car and fix on supports. Remove a forward wheel.
2. Fix steering draught and unscrew a counternut of steering draught on a turn quarter. Do not move a counternut from this position as it will serve as a reference point at installation of a new tip of steering draught.
3. At full unscrewing of a counternut, using a paint, note position of a steering tip on a carving of steering draught.
4. Take шплинт and unscrew a nut of fastening of the spherical hinge of a tip of steering bent for to a rotary fist.
5. Using a stripper, take the spherical hinge of a tip of steering draught from a rotary fist.
6. Unscrew a tip of steering draught from steering draught, having counted exact number of turns of a tip of steering draught.
7. Check up a condition of a protective cover of the spherical hinge of a tip of steering draught.
8. For replacement of a protective cover of the hinge remove a spring ring.
9. Then remove a protective cover on a pin of the spherical hinge.
10. Wipe the hinge pure rags, put on it a greasing layer, establish a new cover and fix its ring.

Installation

PERFORMANCE ORDER
1. Screw a tip of steering draught on steering draught on the same number of turns, as at removal. Thus the counternut of a tip of steering draught should be established on a quarter of a turn from steering draught.
2. Establish the spherical hinge of a tip of steering draught in a rotary fist and fix a nut.
3. Tighten a counternut of fastening of a tip of steering draught.
4. Establish a wheel and lower the car.
5. Check up and, if necessary, adjust corners of installation of forward wheels.