Subaru Legacy

Since 1990-1998 of release

Repair and car operation



Subaru Legasi
+ 1.1. Identification numbers
+ 2. Maintenance service
+ 3. Engines
+ 4. Heating, ventilation
+ 5. Fuel system
+ 6. An exhaust system
+ 7. Systems of start, ignition
+ 8. Transmissions
+ 9. Coupling, shaft
+ 10. Brake system
+ 11. A suspension bracket
- 12. A steering
   12.1. Introduction
   12.2. Technical characteristics
   12.3. A steering wheel
   12.4. Tips of steering draught
   12.5. Replacement of protective covers of steering transfer
   12.6. Steering transfer
   12.7. The pump of the amplifier of a steering
   12.8. Removal of air from system of a steering with the amplifier
+ 13. A body
+ 14. An electric equipment





12.6. Steering transfer

Removal


The prevention

On models with a safety air cushion at work about gauges of collision of a steering column and the panel of devices for an exception of operation of a pillow of safety remove a wire of weight from the accumulator and wait at least 1 minute before the work beginning.


PERFORMANCE ORDER
1. Establish forward wheels for movement directly forward. Lift a forward part of the car and fix on supports.
2. Remove wheels. Remove an engine mudguard.
3. Remove spherical hinges of a tip of steering draught from rotary fists.
4. If it is necessary, remove reception exhaust pipes.
5. Remove a plate поддомкрачивания (the central arrows – bolts of fastening of a plate поддомкрачивания, external arrows – bolts of fastening of steering transfer).
6. Remove the stabilizer of cross-section stability.
7. Establish under steering transfer the corresponding container.
8. Disconnect from the steering transfer, submitting and returnable tubes and close their stoppers.
9. Note mutual position of the bottom universal hinge and an entrance shaft of steering transfer.
10. Unscrew bottom tightening a bolt of an intermediate shaft.
11. Unscrew bolts of fastening of steering transfer and take steering transfer on the right side of the car.

Installation

PERFORMANCE ORDER
Installation is made in sequence of return to removal. Add a liquid in system of the amplifier of a steering. Remove air from system of the amplifier of a steering.