Subaru Legacy

Since 1990-1998 of release

Repair and car operation



Subaru Legasi
+ 1.1. Identification numbers
+ 2. Maintenance service
+ 3. Engines
+ 4. Heating, ventilation
+ 5. Fuel system
+ 6. An exhaust system
+ 7. Systems of start, ignition
+ 8. Transmissions
+ 9. Coupling, shaft
+ 10. Brake system
+ 11. A suspension bracket
- 12. A steering
   12.1. Introduction
   12.2. Technical characteristics
   12.3. A steering wheel
   12.4. Tips of steering draught
   12.5. Replacement of protective covers of steering transfer
   12.6. Steering transfer
   12.7. The pump of the amplifier of a steering
   12.8. Removal of air from system of a steering with the amplifier
+ 13. A body
+ 14. An electric equipment


Журналисты сообщили индивидуальный психолог


12.8. Removal of air from system of a steering with the amplifier
PERFORMANCE ORDER
1. Removal of air from system is necessary for making after рассоединения hydraulic elements of system.
2. Uncover a nutritious tank and check up liquid level.
3. Lift a forward part of the car and fix on supports.
4. At the idle engine slowly some times turn a steering wheel from an emphasis against the stop to remove air from system. Repeat this operation until level in a tank considerably will not decrease.
5. Lower the car. Start the engine and slowly turn a steering wheel from an emphasis against the stop some times to remove air from system.
6. Repeat this operation while bubbles will not cease to appear in a nutritious tank.
7. If at hydraulic system of the amplifier of a steering there is an extraneous noise, it specifies that in system still there is air.
8. After removal of air from system switch off the engine. Give the chance to system to be cooled. Check up liquid level in a tank which should be up to standard of the top label.