Subaru Legacy

Since 1990-1998 of release

Repair and car operation



Subaru Legasi
+ 1.1. Identification numbers
+ 2. Maintenance service
+ 3. Engines
+ 4. Heating, ventilation
+ 5. Fuel system
+ 6. An exhaust system
+ 7. Systems of start, ignition
+ 8. Transmissions
+ 9. Coupling, shaft
+ 10. Brake system
+ 11. A suspension bracket
+ 12. A steering
- 13. A body
   13.1. Introduction
   13.2. Care of a body
   13.3 Care of an upholstery and rugs
   13.4. Repair of insignificant damages of a body
   13.5. Repair of strong damages of a body
   13.6. A cowl
   13.7. Replacement of the lock of a cowl
   13.8. Replacement of a cable of the lock of a cowl
   13.9. A radiator lattice
   13.10. A forward bumper
   13.11. A back bumper
   13.12. A forward wing
   13.13. A door upholstery
   13.14. The lock, the cylinder of the lock and the handle of opening of a door
   13.15. Door glass
   13.16. Стеклоподъемник
   13.17. An external mirror
   13.18. Doors
   13.19. A luggage carrier cover
   13.20. The luggage carrier lock
   13.21. A cable of opening of the lock of a luggage carrier
   13.22. Replacement of racks of support of a back door
   13.23. A back door
   13.24. The lock of a back door, the external handle and the lock cylinder
   13.25. Casings of a steering column
   13.26. The central console
   13.27. Elements of the panel of devices
   13.28. The panel of devices
   13.29. An air inlet lattice
   13.30. Forward seats
+ 14. An electric equipment





13.13. A door upholstery
PERFORMANCE ORDER
1. Remove a wire of weight from the accumulator.
2. On a door with manual стеклоподъемником remove the handle стеклоподъемника for what, using the special tool, take fixing скобу handles.
3. Remove decorative заглушку, unscrew the screw and remove an armrest from a door.
4. Remove decorative заглушку for access to the screw of fastening of an upholstery of a door.
5. Отвинтитие the screw of fastening of an upholstery of a door.
6. Remove decorative заглушку, closing the screw of fastening of a back part of an upholstery of a door.
7. Using a screw-driver or the special tool with a wide edge, separate an upholstery of a door from a door (on the right – the locations скоб fastenings of an upholstery of a door to a door).
8. After branch of an upholstery of a door from a door disconnect electric sockets and remove an upholstery of a door from the car.
9. If it is necessary, remove a protective film from a door.
10. Installation is made in sequence, return to removal.