Subaru Legacy

Since 1990-1998 of release

Repair and car operation



Subaru Legasi
+ 1.1. Identification numbers
+ 2. Maintenance service
+ 3. Engines
+ 4. Heating, ventilation
+ 5. Fuel system
+ 6. An exhaust system
+ 7. Systems of start, ignition
+ 8. Transmissions
+ 9. Coupling, shaft
+ 10. Brake system
+ 11. A suspension bracket
+ 12. A steering
- 13. A body
   13.1. Introduction
   13.2. Care of a body
   13.3 Care of an upholstery and rugs
   13.4. Repair of insignificant damages of a body
   13.5. Repair of strong damages of a body
   13.6. A cowl
   13.7. Replacement of the lock of a cowl
   13.8. Replacement of a cable of the lock of a cowl
   13.9. A radiator lattice
   13.10. A forward bumper
   13.11. A back bumper
   13.12. A forward wing
   13.13. A door upholstery
   13.14. The lock, the cylinder of the lock and the handle of opening of a door
   13.15. Door glass
   13.16. Стеклоподъемник
   13.17. An external mirror
   13.18. Doors
   13.19. A luggage carrier cover
   13.20. The luggage carrier lock
   13.21. A cable of opening of the lock of a luggage carrier
   13.22. Replacement of racks of support of a back door
   13.23. A back door
   13.24. The lock of a back door, the external handle and the lock cylinder
   13.25. Casings of a steering column
   13.26. The central console
   13.27. Elements of the panel of devices
   13.28. The panel of devices
   13.29. An air inlet lattice
   13.30. Forward seats
+ 14. An electric equipment





13.18. Doors

Removal

PERFORMANCE ORDER
1. Close door glass, then disconnect a wire of weight from the accumulator.
2. Open a door and prop up its supports or jacks, having laid between them and a door pure rags.
3. Remove an upholstery of a door and a protective film.
4. Disconnect electric sockets in a door and take them from a door that they did not interfere with door removal.
5. Using a marker, note position of bolts of fastening of hinges of a door.
6. Unscrew bolts of fastening of hinges of a door and remove a door

Installation

Installation is made in sequence, return to removal.

Adjustment

PERFORMANCE ORDER
1. After door installation check up, that the backlash on door perimetre was everywhere identical, and also that the external surface of a door was заподлицо with other elements of a body.
2. For backlash adjustment on door perimetre ослабьте bolts of fastening of hinges of a door and, moving a door, adjust its position then tighten fastening bolts.
3. Check up that the door lock accurately comes on the shock plate located on a rack.
4. If adjustment, ослабьте screws, крепящие a shock plate is necessary, move a shock plate and tighten fastening screws.