Subaru Legacy

Since 1990-1998 of release

Repair and car operation



Subaru Legasi
+ 1.1. Identification numbers
+ 2. Maintenance service
+ 3. Engines
+ 4. Heating, ventilation
+ 5. Fuel system
+ 6. An exhaust system
+ 7. Systems of start, ignition
+ 8. Transmissions
+ 9. Coupling, shaft
+ 10. Brake system
+ 11. A suspension bracket
+ 12. A steering
- 13. A body
   13.1. Introduction
   13.2. Care of a body
   13.3 Care of an upholstery and rugs
   13.4. Repair of insignificant damages of a body
   13.5. Repair of strong damages of a body
   13.6. A cowl
   13.7. Replacement of the lock of a cowl
   13.8. Replacement of a cable of the lock of a cowl
   13.9. A radiator lattice
   13.10. A forward bumper
   13.11. A back bumper
   13.12. A forward wing
   13.13. A door upholstery
   13.14. The lock, the cylinder of the lock and the handle of opening of a door
   13.15. Door glass
   13.16. Стеклоподъемник
   13.17. An external mirror
   13.18. Doors
   13.19. A luggage carrier cover
   13.20. The luggage carrier lock
   13.21. A cable of opening of the lock of a luggage carrier
   13.22. Replacement of racks of support of a back door
   13.23. A back door
   13.24. The lock of a back door, the external handle and the lock cylinder
   13.25. Casings of a steering column
   13.26. The central console
   13.27. Elements of the panel of devices
   13.28. The panel of devices
   13.29. An air inlet lattice
   13.30. Forward seats
+ 14. An electric equipment





13.24. The lock of a back door, the external handle and the lock cylinder
PERFORMANCE ORDER
1. Open a back door and support it in this position.
2. Take clips of fastening of an upholstery of a back door and remove an upholstery of a back door.
The lock
3. Disconnect draught from the cylinder of the lock of a back door.
4. Unscrew two bolts and remove the lock of a back door.
5. Installation is made in sequence, return to removal.
The external handle
6. Disconnect draught from the external handle.
7. Unscrew nuts and remove the external handle of opening of a back door.
The lock cylinder
8. Disconnect draught from the lock cylinder.
9. Unscrew nuts of fastening and remove the cylinder of the lock from a back door.
10. Installation is made in sequence, return to removal.