Subaru Legacy

Since 1990-1998 of release

Repair and car operation



Subaru Legasi
+ 1.1. Identification numbers
+ 2. Maintenance service
+ 3. Engines
+ 4. Heating, ventilation
+ 5. Fuel system
+ 6. An exhaust system
+ 7. Systems of start, ignition
+ 8. Transmissions
+ 9. Coupling, shaft
+ 10. Brake system
+ 11. A suspension bracket
+ 12. A steering
- 13. A body
   13.1. Introduction
   13.2. Care of a body
   13.3 Care of an upholstery and rugs
   13.4. Repair of insignificant damages of a body
   13.5. Repair of strong damages of a body
   13.6. A cowl
   13.7. Replacement of the lock of a cowl
   13.8. Replacement of a cable of the lock of a cowl
   13.9. A radiator lattice
   13.10. A forward bumper
   13.11. A back bumper
   13.12. A forward wing
   13.13. A door upholstery
   13.14. The lock, the cylinder of the lock and the handle of opening of a door
   13.15. Door glass
   13.16. Стеклоподъемник
   13.17. An external mirror
   13.18. Doors
   13.19. A luggage carrier cover
   13.20. The luggage carrier lock
   13.21. A cable of opening of the lock of a luggage carrier
   13.22. Replacement of racks of support of a back door
   13.23. A back door
   13.24. The lock of a back door, the external handle and the lock cylinder
   13.25. Casings of a steering column
   13.26. The central console
   13.27. Elements of the panel of devices
   13.28. The panel of devices
   13.29. An air inlet lattice
   13.30. Forward seats
+ 14. An electric equipment





13.6. A cowl

Removal

PERFORMANCE ORDER
1. Open a cowl and support it in this position.
2. Using a marker, note position of hinges on a cowl.
3. Enclose pure rags under cowl knots to protect a paint and varnish covering of the car at cowl removal.
4. Disconnect electric sockets and wires which connect a cowl to a car body.
5. Having the assistant, support a cowl and remove racks of support of a cowl. Unscrew bolts, крепящие a cowl to hinges.
6. Remove a cowl from the car.

Installation

PERFORMANCE ORDER
1. Installation is made in sequence of return to removal.
2. Level a cowl according to earlier made labels and screw bolts.
3. Adjust cowl position so that at the closed cowl the backlash on cowl perimetre was identical from different directions.
4. If adjustment of position of a shock plate of the lock of a cowl is required, ослабьте bolts of fastening of a shock plate and move it to demanded position then tighten fastening bolts.
5. For adjustment of a forward part of a cowl on height it is necessary to screw in or unscrew the rubber pillows located on a forward cross-beam over headlights.