Subaru Legacy

Since 1990-1998 of release

Repair and car operation



Subaru Legasi
+ 1.1. Identification numbers
+ 2. Maintenance service
+ 3. Engines
+ 4. Heating, ventilation
+ 5. Fuel system
+ 6. An exhaust system
+ 7. Systems of start, ignition
+ 8. Transmissions
+ 9. Coupling, shaft
+ 10. Brake system
+ 11. A suspension bracket
+ 12. A steering
+ 13. A body
- 14. An electric equipment
   - 14.1. A body electric equipment
      14.1.1. Introduction
      14.1.2. Electric chains
      14.1.3. Detection of not closed chain
      14.1.4. Safety locks
      14.1.5. Chain breakers
      14.1.6. The relay
      14.1.7. The relay of turns and the emergency light alarm system
      14.1.8. Multipurpose switches of a steering column
      14.1.9. The ignition lock
      + 14.1.10. Replacement of switches of the panel of devices
      14.1.11. A combination of devices
      14.1.12. A radio receiver
      14.1.13. Loudspeakers
      14.1.14. The aerial
      14.1.15. The aerial with the electric drive
      14.1.16. Replacement of bulbs of headlights
      14.1.17. Adjustment of light of headlights
      14.1.18. A headlight
      14.1.19. Replacement of bulbs накаливания
      14.1.20. The screen wiper engine
      14.1.21. A sound signal
      14.1.22. Check of a heater of back glass
      14.1.23. Стеклоподъемники with the electric drive
      14.1.24. Rear-view mirrors with the electric drive
      14.1.25. A safety air cushion
   + 14.2. Electroschemes





14.1.11. A combination of devices
THE GENERAL DATA

Arrangement of screws of fastening of a combination of devices on models with 1990 for 1994


Arrangement of screws of fastening of a combination of devices on models since 1995


PERFORMANCE ORDER
1. Remove a wire of weight from the accumulator.
2. Remove a decorative overlay of a combination of devices.
3. Unscrew screws of fastening of a combination of devices and move a combination of devices to a steering wheel.
4. Disconnect electric sockets and a cable of a drive of a speedometer from a back part of a combination of devices and remove a combination of devices.
5. Installation is made in sequence, return to removal.