Subaru Legacy

Since 1990-1998 of release

Repair and car operation



Subaru Legasi
+ 1.1. Identification numbers
+ 2. Maintenance service
+ 3. Engines
+ 4. Heating, ventilation
+ 5. Fuel system
+ 6. An exhaust system
+ 7. Systems of start, ignition
+ 8. Transmissions
+ 9. Coupling, shaft
+ 10. Brake system
+ 11. A suspension bracket
+ 12. A steering
+ 13. A body
- 14. An electric equipment
   - 14.1. A body electric equipment
      14.1.1. Introduction
      14.1.2. Electric chains
      14.1.3. Detection of not closed chain
      14.1.4. Safety locks
      14.1.5. Chain breakers
      14.1.6. The relay
      14.1.7. The relay of turns and the emergency light alarm system
      14.1.8. Multipurpose switches of a steering column
      14.1.9. The ignition lock
      + 14.1.10. Replacement of switches of the panel of devices
      14.1.11. A combination of devices
      14.1.12. A radio receiver
      14.1.13. Loudspeakers
      14.1.14. The aerial
      14.1.15. The aerial with the electric drive
      14.1.16. Replacement of bulbs of headlights
      14.1.17. Adjustment of light of headlights
      14.1.18. A headlight
      14.1.19. Replacement of bulbs накаливания
      14.1.20. The screen wiper engine
      14.1.21. A sound signal
      14.1.22. Check of a heater of back glass
      14.1.23. Стеклоподъемники with the electric drive
      14.1.24. Rear-view mirrors with the electric drive
      14.1.25. A safety air cushion
   + 14.2. Electroschemes





14.1.16. Replacement of bulbs of headlights
THE GENERAL DATA

The prevention

Before replacement of a bulb of external illumination check up a corresponding electric chain and a safety lock. Do not concern a glass flask of a lamp barehanded. The fingerprint evaporates and besieged on a reflector therefore illumination worsens. Necessarily replace the failed lamps with lamps of the same type. Stains arising on imprudence from touches wipe pure безворсовой a rag or spirit.


PERFORMANCE ORDER
1. Remove a wire of weight from the accumulator.
2. Release a clamp and disconnect from the holder of a bulb of a headlight.
3. Remove a rubber protective cover, compress a spring clamp and take the holder of a bulb from a headlight casing.
4. Establish the holder of a bulb with a new bulb in a headlight and fix a spring clamp.
5. Establish a rubber protective cover, and the inscription of TORAHS should be above.
6. Connect an electric socket to the holder of a bulb of a headlight.
7. Check up and, if necessary, adjust light of headlights.