Subaru Legacy

Since 1990-1998 of release

Repair and car operation



Subaru Legasi
+ 1.1. Identification numbers
+ 2. Maintenance service
+ 3. Engines
+ 4. Heating, ventilation
+ 5. Fuel system
+ 6. An exhaust system
+ 7. Systems of start, ignition
+ 8. Transmissions
+ 9. Coupling, shaft
+ 10. Brake system
+ 11. A suspension bracket
+ 12. A steering
+ 13. A body
- 14. An electric equipment
   - 14.1. A body electric equipment
      14.1.1. Introduction
      14.1.2. Electric chains
      14.1.3. Detection of not closed chain
      14.1.4. Safety locks
      14.1.5. Chain breakers
      14.1.6. The relay
      14.1.7. The relay of turns and the emergency light alarm system
      14.1.8. Multipurpose switches of a steering column
      14.1.9. The ignition lock
      + 14.1.10. Replacement of switches of the panel of devices
      14.1.11. A combination of devices
      14.1.12. A radio receiver
      14.1.13. Loudspeakers
      14.1.14. The aerial
      14.1.15. The aerial with the electric drive
      14.1.16. Replacement of bulbs of headlights
      14.1.17. Adjustment of light of headlights
      14.1.18. A headlight
      14.1.19. Replacement of bulbs накаливания
      14.1.20. The screen wiper engine
      14.1.21. A sound signal
      14.1.22. Check of a heater of back glass
      14.1.23. Стеклоподъемники with the electric drive
      14.1.24. Rear-view mirrors with the electric drive
      14.1.25. A safety air cushion
   + 14.2. Electroschemes





14.1.18. A headlight
THE GENERAL DATA

Arrangement of the lateral internal screw of fastening of a headlight


Arrangement of the lateral external screw of fastening of a headlight


The prevention

Do not concern a glass flask of a lamp barehanded. The fingerprint evaporates and besieged on a reflector therefore illumination worsens. Necessarily replace the failed lamps with lamps of the same type.


PERFORMANCE ORDER
1. Remove a wire of weight from the accumulator.
2. Remove a headlight bulb.
3. Remove a radiator lattice.
4. Remove lateral dimensional fires.
5. Unscrew bolts of fastening of a headlight and remove a headlight from the car.
6. Installation is made in sequence, return to removal. Check up and, if necessary, adjust light of headlights.