Subaru Legacy

Since 1990-1998 of release

Repair and car operation



Subaru Legasi
+ 1.1. Identification numbers
+ 2. Maintenance service
+ 3. Engines
+ 4. Heating, ventilation
+ 5. Fuel system
+ 6. An exhaust system
+ 7. Systems of start, ignition
+ 8. Transmissions
+ 9. Coupling, shaft
+ 10. Brake system
+ 11. A suspension bracket
+ 12. A steering
+ 13. A body
- 14. An electric equipment
   - 14.1. A body electric equipment
      14.1.1. Introduction
      14.1.2. Electric chains
      14.1.3. Detection of not closed chain
      14.1.4. Safety locks
      14.1.5. Chain breakers
      14.1.6. The relay
      14.1.7. The relay of turns and the emergency light alarm system
      14.1.8. Multipurpose switches of a steering column
      14.1.9. The ignition lock
      + 14.1.10. Replacement of switches of the panel of devices
      14.1.11. A combination of devices
      14.1.12. A radio receiver
      14.1.13. Loudspeakers
      14.1.14. The aerial
      14.1.15. The aerial with the electric drive
      14.1.16. Replacement of bulbs of headlights
      14.1.17. Adjustment of light of headlights
      14.1.18. A headlight
      14.1.19. Replacement of bulbs накаливания
      14.1.20. The screen wiper engine
      14.1.21. A sound signal
      14.1.22. Check of a heater of back glass
      14.1.23. Стеклоподъемники with the electric drive
      14.1.24. Rear-view mirrors with the electric drive
      14.1.25. A safety air cushion
   + 14.2. Electroschemes





14.1.22. Check of a heater of back glass
THE GENERAL DATA

The heater of back glass represents set of the horizontal conductors which have been raised dust on an internal surface of back glass.

PERFORMANCE ORDER
1. For detection of rupture of a conductor of a heater of back glass include ignition and include a heater of back glass.
2. Connect one щуп the voltmeter to weight of the car, and the second щуп wrap up a foil and move a foil on a heater conductor.
3. Connect щуп the voltmeter in the centre of each conductor of a heater of back glass. If the voltmeter shows pressure nearby 5 In, means, the heater conductor is serviceable. If the voltmeter shows pressure 0 In or 12 In, means there is a rupture of a conductor of a heater.
4. For detection of a place of rupture of a conductor of a heater connect one щуп the voltmeter to the positive plug of a heater, and the second щуп move on a heater conductor from outside the negative plug of a heater. The point in which the pressure shown by the voltmeter, will fall about several volt to zero and is a place of rupture of a conductor of a heater.
5. To restore the broken off conductor of a heater of back glass it is possible with application of current-carrying paste.
6. Before the repair beginning switch off heating of back glass and give time for glass cooling.
7. Being careful, smooth out a conductor of a heater and wash out its spirit.
8. Take advantage of a sticky tape for a mark of a repaired site.
9. Put electrowire paste approximately on 20 mm from each end of the damaged conductor.
10. After drying of electrospending paste within 24 hours it is possible to use a heater of back glass.