Subaru Legacy

Since 1990-1998 of release

Repair and car operation



Subaru Legasi
+ 1.1. Identification numbers
+ 2. Maintenance service
+ 3. Engines
+ 4. Heating, ventilation
+ 5. Fuel system
+ 6. An exhaust system
+ 7. Systems of start, ignition
+ 8. Transmissions
+ 9. Coupling, shaft
+ 10. Brake system
+ 11. A suspension bracket
+ 12. A steering
+ 13. A body
- 14. An electric equipment
   - 14.1. A body electric equipment
      14.1.1. Introduction
      14.1.2. Electric chains
      14.1.3. Detection of not closed chain
      14.1.4. Safety locks
      14.1.5. Chain breakers
      14.1.6. The relay
      14.1.7. The relay of turns and the emergency light alarm system
      14.1.8. Multipurpose switches of a steering column
      14.1.9. The ignition lock
      + 14.1.10. Replacement of switches of the panel of devices
      14.1.11. A combination of devices
      14.1.12. A radio receiver
      14.1.13. Loudspeakers
      14.1.14. The aerial
      14.1.15. The aerial with the electric drive
      14.1.16. Replacement of bulbs of headlights
      14.1.17. Adjustment of light of headlights
      14.1.18. A headlight
      14.1.19. Replacement of bulbs накаливания
      14.1.20. The screen wiper engine
      14.1.21. A sound signal
      14.1.22. Check of a heater of back glass
      14.1.23. Стеклоподъемники with the electric drive
      14.1.24. Rear-view mirrors with the electric drive
      14.1.25. A safety air cushion
   + 14.2. Electroschemes





14.1.24. Rear-view mirrors with the electric drive
THE GENERAL DATA

Arrangement of contacts on an electric socket of the switch of adjustment of position of a mirror and a condition of contacts at various positions of the switch

For management of position of an external rear-view mirror it is used in each mirror on two electric motors.

Adjustment of position of an external rear-view mirror with the electric drive is possible only after ignition inclusion.

For check of working capacity of the engine include the switch and listen, whether there is a sound of the working engine.

If the engine works, but the mirror does not move, possibly, there is a defect of a drive in a mirror.

If the mirror does not move also the engine does not work, check up a safety lock of an electric chain of a drive of a mirror.

If the safety lock is serviceable, remove from the panel of devices the switch of adjustment of position of a mirror and check up, whether pressure moves to it.

If pressure moves to the switch, disconnect from it an electric socket and, using an ohmmeter, check up a condition of contacts of the switch depending on switch position (the Arrangement of contacts fig. see an electric socket of the switch of adjustment of position of a mirror and a condition of contacts at various positions of the switch).