Subaru Legacy

Since 1990-1998 of release

Repair and car operation



Subaru Legasi
+ 1.1. Identification numbers
+ 2. Maintenance service
+ 3. Engines
+ 4. Heating, ventilation
+ 5. Fuel system
+ 6. An exhaust system
+ 7. Systems of start, ignition
+ 8. Transmissions
+ 9. Coupling, shaft
+ 10. Brake system
+ 11. A suspension bracket
+ 12. A steering
+ 13. A body
- 14. An electric equipment
   - 14.1. A body electric equipment
      14.1.1. Introduction
      14.1.2. Electric chains
      14.1.3. Detection of not closed chain
      14.1.4. Safety locks
      14.1.5. Chain breakers
      14.1.6. The relay
      14.1.7. The relay of turns and the emergency light alarm system
      14.1.8. Multipurpose switches of a steering column
      14.1.9. The ignition lock
      + 14.1.10. Replacement of switches of the panel of devices
      14.1.11. A combination of devices
      14.1.12. A radio receiver
      14.1.13. Loudspeakers
      14.1.14. The aerial
      14.1.15. The aerial with the electric drive
      14.1.16. Replacement of bulbs of headlights
      14.1.17. Adjustment of light of headlights
      14.1.18. A headlight
      14.1.19. Replacement of bulbs накаливания
      14.1.20. The screen wiper engine
      14.1.21. A sound signal
      14.1.22. Check of a heater of back glass
      14.1.23. Стеклоподъемники with the electric drive
      14.1.24. Rear-view mirrors with the electric drive
      14.1.25. A safety air cushion
   + 14.2. Electroschemes





14.1.9. The ignition lock
THE GENERAL DATA

The lock of ignition and condition of contacts on a socket at various positions of a key in the ignition lock

Check

PERFORMANCE ORDER
1. Remove the bottom casing of a steering column.
2. Unscrew screws and remove a steel protective plate from the bottom part of a steering column.
3. Disconnect an electric socket of the lock of ignition.
4. Using an ohmmeter, check up a condition of contacts of the lock of ignition depending on ignition key position (the Lock of ignition and a condition of contacts fig. see a socket at various positions of a key in the ignition lock).

Replacement

PERFORMANCE ORDER
1. Remove a wire of weight from the accumulator.
2. Remove a casing of a steering column.
3. Unscrew screws and remove a steel protective plate from the bottom part of a steering column.
4. Disconnect an electric socket of the lock of ignition.
5. Unscrew the screw, крепящий contact group of the lock of ignition to a casing of the cylinder of the lock.
6. Take contact group of the lock of ignition of a casing.
7. Unscrew bolts, крепящие a casing of the cylinder of the lock of ignition.
8. Installation is made in sequence, return to removal.
9. Thus it is necessary to use new bolts with a cut off head for fastening of a casing of the cylinder of the lock of ignition.