Subaru Legacy

Since 1990-1998 of release

Repair and car operation



Subaru Legasi
+ 1.1. Identification numbers
- 2. Maintenance service
   2.1. Introduction
   2.2. Technical characteristics
   2.3. Periodicity of service
   2.4. Check of level of engine oil
   2.5. Level of a cooling liquid
   2.6. Level of a brake liquid and a liquid of a drive of coupling
   2.7. A liquid for a windscreen washer
   2.8. Accumulator check
   2.9. Tyres and pressure check in tyres
   2.10. Check of level of oil in an automatic transmission
   2.11. Check of level of a liquid in the steering amplifier
   2.12. Replacement of oil and the oil filter
   2.13. Check and accumulator service
   2.14. Accumulator gymnastics
   2.15. Check of system of cooling
   2.16. Check of hoses, tubes and their replacement
   2.17. Check and replacement of brushes of screen wipers
   2.18. Shift of tyres
   2.19. Suspension bracket and steering check
   2.20. Exhaust system check
   2.21. Check of level of oil in a transmission and the main transfer
   2.22. Check of level of oil in differential (the main transfer)
   2.23. Check of brake system
   2.24. Check of the vacuum amplifier of brakes
   2.25. Check of a manual brake
   2.26. Check of fuel system
   2.27. Replacement of the fuel filter
   2.28. Check and replacement приводного a belt
   2.29. Check of a free wheeling of a pedal of a brake
   2.30. Check of a free wheeling of a pedal of coupling
   2.31. Check and replacement of spark plugs
   2.32. Check of high-voltage wires
   2.33. Check and adjustment of turns of idling
   2.34. Replacement of the air filter
   2.35. Check and replacement of the valve of ventilation картера (PCV)
   2.36. Check of system of catching of steams of fuel
   2.37. Check of system of repeated burning of the fulfilled gases (EGR)
   2.38. Service of system of cooling
   2.39. Replacement of a brake liquid
   2.40. Oil replacement in an automatic transmission
   2.41. Oil replacement in a mechanical transmission
   2.42. Check and adjustment of backlashes of valves
   + 2.43. The basic malfunctions
+ 3. Engines
+ 4. Heating, ventilation
+ 5. Fuel system
+ 6. An exhaust system
+ 7. Systems of start, ignition
+ 8. Transmissions
+ 9. Coupling, shaft
+ 10. Brake system
+ 11. A suspension bracket
+ 12. A steering
+ 13. A body
+ 14. An electric equipment





2.23. Check of brake system
THE GENERAL DATA

The prevention

At work brake колодок the brake dust which contains asbestos, unhealthy is formed, therefore at clearing brake колодок do not use compressed air and do not inhale a dust.


Examine brakes through the recommended intervals and at each removal of wheels.

The symptoms specifying in potential malfunctions of brakes: the car deviates aside at braking, noise at the braking, the increased course of a pedal of a brake, a pulsation of effort to pedals, leak of a brake liquid, especially on a lateral surface of the tyre.

PERFORMANCE ORDER
1. Lift a corresponding part of the car and fix on supports. Remove a wheel.
Disk brakes
2. In disk brakes two are applied brake колодки – external and internal. Колодки are visible through viewing apertures in supports (are specified by arrows). Check up a thickness brake колодок and, if necessary, replace them.
3. If it is visually difficult to define a thickness brake колодок, remove a support and take brake колодки for the further survey. Measure a thickness brake колодок. Thus, if a thickness of a frictional layer less admissible, replace brake колодку.
4. Measure a thickness of brake disks by means of a micrometer. If a thickness of a brake disk less admissible, replace a brake disk. Replacement of a brake disk is made also in the presence of cracks, zones of an overheat and other damages.
5. Before installation of wheels check up a condition and freedom of moving of brake hoses (are specified by arrows). Thus there should be no a contact to any sharp sides.
Drum-type brakes
6. For survey brake колодок remove back brake drums.
7. Check up a condition of a frictional layer brake колодки. If the surface of a frictional layer is made oily, replace brake колодку.
8. Examine a condition of returnable and keeping springs.
9. Отворачивание a protective cover of the working brake cylinder. Examine the working brake cylinder and a condition of protective covers. In the presence of leaks of a brake liquid replace the brake cylinder.
10. Examine a condition of a brake drum.
11. Establish brake drums.
12. Establish wheels and lower the car.