Subaru Legacy

Since 1990-1998 of release

Repair and car operation



Subaru Legasi
+ 1.1. Identification numbers
+ 2. Maintenance service
- 3. Engines
   3.1. Technical characteristics
   3.2. Operations on repair of the engine established in the car
   3.3. The top dead point of the first cylinder
   3.4. A cover of a head of the block of cylinders
   3.5. An inlet collector
   + 3.6. A gear belt and pulleys
   3.7. Replacement of a forward sealing ring of a cranked shaft
   3.8. Replacement of sealing rings of camshafts
   3.9. Camshafts and pushers
   3.10. Heads of the block of cylinders
   3.11. The oil pallet
   3.12. The oil pump
   3.13. The Flywheel / a drive plate
   3.14. Replacement of a back sealing ring of a cranked shaft
   3.15. A suspension bracket of the power unit
   + 3.16. Engine major repairs
+ 4. Heating, ventilation
+ 5. Fuel system
+ 6. An exhaust system
+ 7. Systems of start, ignition
+ 8. Transmissions
+ 9. Coupling, shaft
+ 10. Brake system
+ 11. A suspension bracket
+ 12. A steering
+ 13. A body
+ 14. An electric equipment





3.11. The oil pallet
THE GENERAL DATA

Arrangement of bolts of fastening of the oil pallet


Arrangement of bolts of fastening of a tube маслоприемника

Removal

PERFORMANCE ORDER
1. Remove a wire of weight from the accumulator. Lift the car and reliably fix on supports.
2. Merge engine oil and unscrew the oil filter.
3. Unscrew nuts of fastening of support of the engine, then, using the load-lifting mechanism, raise the engine on 50 mm.
4. Unscrew bolts, крепящие the oil pallet to the block of cylinders of the engine (fig. the Arrangement of bolts of fastening of the oil pallet see).
5. Remove the oil pallet from the engine together with a lining.
6. If necessary unscrew bolts and lift the receiver маслоприемника (fig. the Arrangement of bolts of fastening of a tube маслоприемника see).

Installation

PERFORMANCE ORDER
1. Clear all traces of a dirt and oil from interfaced surfaces of the block of cylinders and the oil pallet.
2. Check up a condition of the mesh filter маслоприемника and, if necessary, clear it.
3. Apply a thin film hermetic on a lining of the oil pallet and establish a lining on the oil pallet.
4. Establish the oil pallet on the block of cylinders and fix bolts, having tightened their demanded moment.
5. The further installation is made in sequence, return to removal.