Subaru Legacy

Since 1990-1998 of release

Repair and car operation



Subaru Legasi
+ 1.1. Identification numbers
+ 2. Maintenance service
- 3. Engines
   3.1. Technical characteristics
   3.2. Operations on repair of the engine established in the car
   3.3. The top dead point of the first cylinder
   3.4. A cover of a head of the block of cylinders
   3.5. An inlet collector
   + 3.6. A gear belt and pulleys
   3.7. Replacement of a forward sealing ring of a cranked shaft
   3.8. Replacement of sealing rings of camshafts
   3.9. Camshafts and pushers
   3.10. Heads of the block of cylinders
   3.11. The oil pallet
   3.12. The oil pump
   3.13. The Flywheel / a drive plate
   3.14. Replacement of a back sealing ring of a cranked shaft
   3.15. A suspension bracket of the power unit
   + 3.16. Engine major repairs
+ 4. Heating, ventilation
+ 5. Fuel system
+ 6. An exhaust system
+ 7. Systems of start, ignition
+ 8. Transmissions
+ 9. Coupling, shaft
+ 10. Brake system
+ 11. A suspension bracket
+ 12. A steering
+ 13. A body
+ 14. An electric equipment





3.13. The Flywheel / a drive plate

Removal

PERFORMANCE ORDER
1. Lift the car and remove a transmission.
2. Using a marker or a paint, note position of leading knot of coupling in relation to a flywheel.
3. Gradually in diagonal sequence, ослабьте bolts of fastening of leading knot of coupling, turning each bolt on half of turn until spring action will stop, and bolts can be unscrewed manually.
4. Remove leading knot of coupling and a disk of coupling from a flywheel.
5. Fix a flywheel from проворачивания, having established a clamp on a gear wreath of a flywheel. Put combination labels on a flywheel and a cranked shaft.
6. Unscrew bolts and remove a flywheel.

Installation

PERFORMANCE ORDER
1. On models with a mechanical transmission check up a flywheel on deterioration from outside couplings and a condition of teeths of a gear wreath.
2. Clear interfaced surfaces of a flywheel and a cranked shaft. Establish a flywheel according to earlier put labels and fix bolts.
3. Fix a flywheel from проворачивания and definitively tighten bolts of fastening of a flywheel.
4. The further installation is made in sequence, return to removal.