Subaru Legacy

Since 1990-1998 of release

Repair and car operation



Subaru Legasi
+ 1.1. Identification numbers
+ 2. Maintenance service
- 3. Engines
   3.1. Technical characteristics
   3.2. Operations on repair of the engine established in the car
   3.3. The top dead point of the first cylinder
   3.4. A cover of a head of the block of cylinders
   3.5. An inlet collector
   + 3.6. A gear belt and pulleys
   3.7. Replacement of a forward sealing ring of a cranked shaft
   3.8. Replacement of sealing rings of camshafts
   3.9. Camshafts and pushers
   3.10. Heads of the block of cylinders
   3.11. The oil pallet
   3.12. The oil pump
   3.13. The Flywheel / a drive plate
   3.14. Replacement of a back sealing ring of a cranked shaft
   3.15. A suspension bracket of the power unit
   + 3.16. Engine major repairs
+ 4. Heating, ventilation
+ 5. Fuel system
+ 6. An exhaust system
+ 7. Systems of start, ignition
+ 8. Transmissions
+ 9. Coupling, shaft
+ 10. Brake system
+ 11. A suspension bracket
+ 12. A steering
+ 13. A body
+ 14. An electric equipment





3.15. A suspension bracket of the power unit
THE GENERAL DATA

Arrangement of a nut of fastening of the right support of the engine


Arrangement of a nut of fastening of the left support of the engine

Check

PERFORMANCE ORDER
1. For access improvement to a suspension bracket of the power unit lift a forward part of the car and fix on supports.
2. Check up a condition of rubber elements of a suspension bracket on presence of cracks, ageing and stratification.
3. Check up reliability of fastening of engine mounts.
4. Moving the engine here and there, check up люфт in engine mounts. Люфт should be insignificant even at new elements of a suspension bracket.

Replacement

PERFORMANCE ORDER
1. Remove a wire of weight from the accumulator. Using the load-lifting mechanism, support the engine.
2. Unscrew nuts of fastening of a support of the engine to a beam (fig. the Arrangement of a nut of fastening of the right support of the engine, the Arrangement of a nut of fastening of the left support of the engine see).
3. Using the load-lifting mechanism, slightly raise the engine.
4. Unscrew two bolts, крепящие an engine support to the block of cylinders and remove an engine support.
5. Establish a support located between the engine and a beam and fix bolts.
6. Slowly lower the engine, thus two bottom racks should pass in a corresponding aperture in a beam. Tighten bolts of fastening of support of the engine to a beam.