Subaru Legacy

Since 1990-1998 of release

Repair and car operation



Subaru Legasi
+ 1.1. Identification numbers
+ 2. Maintenance service
- 3. Engines
   3.1. Technical characteristics
   3.2. Operations on repair of the engine established in the car
   3.3. The top dead point of the first cylinder
   3.4. A cover of a head of the block of cylinders
   3.5. An inlet collector
   + 3.6. A gear belt and pulleys
   3.7. Replacement of a forward sealing ring of a cranked shaft
   3.8. Replacement of sealing rings of camshafts
   3.9. Camshafts and pushers
   3.10. Heads of the block of cylinders
   3.11. The oil pallet
   3.12. The oil pump
   3.13. The Flywheel / a drive plate
   3.14. Replacement of a back sealing ring of a cranked shaft
   3.15. A suspension bracket of the power unit
   + 3.16. Engine major repairs
+ 4. Heating, ventilation
+ 5. Fuel system
+ 6. An exhaust system
+ 7. Systems of start, ignition
+ 8. Transmissions
+ 9. Coupling, shaft
+ 10. Brake system
+ 11. A suspension bracket
+ 12. A steering
+ 13. A body
+ 14. An electric equipment





3.4. A cover of a head of the block of cylinders Removal and installation

PERFORMANCE ORDER
1. Remove a wire of weight from the accumulator.
2. Lift the receiver an air inlet and assemblage of the air filter for access to the right cover of a head of the block of cylinders.
3. Remove high-voltage wires from spark plugs.
4. Remove the accumulator and a support of the accumulator for access to the left cover of a head of the block of cylinders.
5. Remove a tank of a washer of a windscreen from a motor compartment.
6. Unscrew bolts (are specified by arrows) and uncover heads of the block of cylinders.
7. Installation is made in sequence, return to removal. Thus it is necessary to establish a new lining of a cover of a head of the block of cylinders.