Subaru Legacy

Since 1990-1998 of release

Repair and car operation



Subaru Legasi
+ 1.1. Identification numbers
+ 2. Maintenance service
+ 3. Engines
- 4. Heating, ventilation
   - 4.1. Cooling system
      4.1.1. Introduction
      4.1.2. Technical characteristics
      4.1.3. Antifreeze
      4.1.4. Check and thermostat replacement
      4.1.5. Check and replacement of the fan of a radiator and the relay
      4.1.6. A radiator
      4.1.7. A broad tank
      4.1.8. The water pump
      4.1.9. The gauge of temperature of a cooling liquid
   + 4.2. Heating system
   + 4.3. Air central air
   4.4. Climate control system
+ 5. Fuel system
+ 6. An exhaust system
+ 7. Systems of start, ignition
+ 8. Transmissions
+ 9. Coupling, shaft
+ 10. Brake system
+ 11. A suspension bracket
+ 12. A steering
+ 13. A body
+ 14. An electric equipment





4.1.6. A radiator
THE GENERAL DATA

Radiator and the fan

1 – a casing
2 – the fan
3 – a stopper
4 – a hose
5 – an arm
6 – a broad tank
7 – a collar
8 – the top hose of a radiator
9 – the bottom hose of a radiator
10 – a radiator suspension bracket
11 – the top lining
12 – a stopper of removal of air
13 – a radiator
14 – the bottom lining
15 – a radiator
16 – an inlet hose from a transmission
17 – a final hose from a transmission
18 – a collar
19 – metal pipelines
20 – an inlet hose from a transmission
21 – a final hose from a transmission

Replacement
The prevention

Radiator replacement make on the cold engine.


PERFORMANCE ORDER
1. Merge cooling liquid from cooling system.
2. Remove a wire of weight from the accumulator.
3. Ослабьте collars (are specified by arrows) and remove hoses from a radiator.
4. On models with an automatic transmission disconnect hoses from an oil radiator.
5. Disconnect an electric socket of the engine of the fan of a radiator and the tyre of grounding of a radiator.
6. Unscrew bolts of fastening of a radiator (are specified by arrows).
7. Remove a radiator, lifting it upwards from rubber pillows.
8. Installation is made in sequence, return to removal.
9. Fill in cooling liquid in cooling system.