Subaru Legacy

Since 1990-1998 of release

Repair and car operation



Subaru Legasi
+ 1.1. Identification numbers
+ 2. Maintenance service
+ 3. Engines
- 4. Heating, ventilation
   - 4.1. Cooling system
      4.1.1. Introduction
      4.1.2. Technical characteristics
      4.1.3. Antifreeze
      4.1.4. Check and thermostat replacement
      4.1.5. Check and replacement of the fan of a radiator and the relay
      4.1.6. A radiator
      4.1.7. A broad tank
      4.1.8. The water pump
      4.1.9. The gauge of temperature of a cooling liquid
   + 4.2. Heating system
   + 4.3. Air central air
   4.4. Climate control system
+ 5. Fuel system
+ 6. An exhaust system
+ 7. Systems of start, ignition
+ 8. Transmissions
+ 9. Coupling, shaft
+ 10. Brake system
+ 11. A suspension bracket
+ 12. A steering
+ 13. A body
+ 14. An electric equipment





4.1.9. The gauge of temperature of a cooling liquid
THE GENERAL DATA

Arrangement of gauges of temperature of a cooling liquid of the index температурыи the management block

The gauge of temperature of the index of temperature (1) on combinations of devices and the gauge of temperature of the block of management (2) are located under an inlet collector on the right side.

Check

PERFORMANCE ORDER
1. If the temperature index does not work, check up fuses in an electric chain.
2. If the temperature index shows a heat at start of the cold engine, disconnect a wire from the temperature gauge. If the temperature index shows low temperature of the engine, replace the gauge of temperature of a cooling liquid.
3. If the index still shows a heat, check up a condition of an electric chain from the gauge to the index or the index of temperature of a cooling liquid.
4. If the index of temperature of a cooling liquid does not show any temperature after warming up of the engine and a safety lock in a normal state, disconnect a wire from the gauge of temperature and connect it to weight of the car. For short time include ignition, without starting the engine.
5. If the temperature index shows an engine heat, replace the gauge of temperature of a cooling liquid. If the arrow of the index remains on a place, check up a condition of an electric chain or serviceability of the index of temperature of a cooling liquid.

Replacement

PERFORMANCE ORDER
1. Prepare the new gauge of temperature of a cooling liquid for its installation in the engine, having put on a gauge carving a thin layer of hermetic.
2. Disconnect an electric socket from the gauge of temperature of a cooling liquid.
3. Unscrew the gauge of temperature of a cooling liquid.
4. As soon as possible screw in the new gauge and tighten its demanded moment. Connect to the gauge an electric socket and add cooling liquid in cooling system.