Subaru Legacy

Since 1990-1998 of release

Repair and car operation



Subaru Legasi
+ 1.1. Identification numbers
+ 2. Maintenance service
+ 3. Engines
+ 4. Heating, ventilation
- 5. Fuel system
   5.1. Introduction
   5.2. Technical characteristics
   5.3. Pressure removal in fuel system
   5.4. Check of the fuel pump
   5.5. The fuel pump
   5.6. A fuel separator (only models 4WD)
   5.7. The gauge of level of fuel
   5.8. A fuel tank
   5.9. A casing of the air filter
   5.10. An accelerator cable
   5.11. Electronic system of injection of fuel
   5.12. Fuel system
   5.13. System of giving of air
   5.14. Electronic control system
   5.15. Check of system of injection of fuel
   + 5.16. Check and replacement of elements of system of injection of fuel
   5.17. Турбонагнетатель
   5.18. Check of the executive mechanism заслонки турбонагнетателя
   5.19. The general check турбонагнетателя
   5.20. Removal and installation турбонагнетателя
+ 6. An exhaust system
+ 7. Systems of start, ignition
+ 8. Transmissions
+ 9. Coupling, shaft
+ 10. Brake system
+ 11. A suspension bracket
+ 12. A steering
+ 13. A body
+ 14. An electric equipment





5.3. Pressure removal in fuel system
PERFORMANCE ORDER
1. Uncover топливозаливной mouths to level pressure in a tank with the atmospheric.
2. Remove a back seat (the car with a body of type "sedan") or a carpet covering for access to the block of the fuel pump with a measuring instrument of level of fuel.
3. Disconnect an electric socket (it is specified by an arrow) from the fuel pump.
4. Start the engine in a mode of idling to an engine stop therefore pressure in fuel system will decrease to zero.
5. After the termination of works on fuel system repeatedly connect an electric socket of the fuel pump.