Subaru Legacy

Since 1990-1998 of release

Repair and car operation



Subaru Legasi
+ 1.1. Identification numbers
+ 2. Maintenance service
+ 3. Engines
+ 4. Heating, ventilation
- 5. Fuel system
   5.1. Introduction
   5.2. Technical characteristics
   5.3. Pressure removal in fuel system
   5.4. Check of the fuel pump
   5.5. The fuel pump
   5.6. A fuel separator (only models 4WD)
   5.7. The gauge of level of fuel
   5.8. A fuel tank
   5.9. A casing of the air filter
   5.10. An accelerator cable
   5.11. Electronic system of injection of fuel
   5.12. Fuel system
   5.13. System of giving of air
   5.14. Electronic control system
   5.15. Check of system of injection of fuel
   + 5.16. Check and replacement of elements of system of injection of fuel
   5.17. Турбонагнетатель
   5.18. Check of the executive mechanism заслонки турбонагнетателя
   5.19. The general check турбонагнетателя
   5.20. Removal and installation турбонагнетателя
+ 6. An exhaust system
+ 7. Systems of start, ignition
+ 8. Transmissions
+ 9. Coupling, shaft
+ 10. Brake system
+ 11. A suspension bracket
+ 12. A steering
+ 13. A body
+ 14. An electric equipment





5.5. The fuel pump
THE GENERAL DATA

Removal of percussion caps of fastening of a carpet for access to a cover of the fuel pump


Arrangement of the gauge of level of fuel and the block of the gauge of level of fuel / of the fuel pump on models 4WD


Removal and installation

PERFORMANCE ORDER
1. Remove pressure in fuel system. Remove a wire of weight from the accumulator.
2. Remove a back seat (the car with a body of type "sedan") or a carpet covering (the car with a body "versatile person") for access to a cover of the fuel pump (Removal of percussion caps of fastening of a carpet for access to a cover of the fuel pump, fig. the Arrangement of the gauge of level of fuel and the block of the gauge of level of fuel / of the fuel pump fig. see models 4WD).
3. Unscrew screws of fastening of a cover of the fuel pump and lift a cover.
4. Disconnect an electric socket of the fuel pump.
5. Ослабьте collars also remove hoses from unions of the fuel pump. On models 4WD also remove a hose of the pumping over pump.
6. Unscrew bolts of fastening of the fuel pump.
7. Take assemblage of the fuel pump from a fuel tank.
8. Disconnect an internal electric socket.
9. Remove топливопровод.
10. Release fastening and remove the fuel pump.
10. Installation is made in sequence, return to removal.