Subaru Legacy

Since 1990-1998 of release

Repair and car operation



Subaru Legasi
+ 1.1. Identification numbers
+ 2. Maintenance service
+ 3. Engines
+ 4. Heating, ventilation
- 5. Fuel system
   5.1. Introduction
   5.2. Technical characteristics
   5.3. Pressure removal in fuel system
   5.4. Check of the fuel pump
   5.5. The fuel pump
   5.6. A fuel separator (only models 4WD)
   5.7. The gauge of level of fuel
   5.8. A fuel tank
   5.9. A casing of the air filter
   5.10. An accelerator cable
   5.11. Electronic system of injection of fuel
   5.12. Fuel system
   5.13. System of giving of air
   5.14. Electronic control system
   5.15. Check of system of injection of fuel
   + 5.16. Check and replacement of elements of system of injection of fuel
   5.17. Турбонагнетатель
   5.18. Check of the executive mechanism заслонки турбонагнетателя
   5.19. The general check турбонагнетателя
   5.20. Removal and installation турбонагнетателя
+ 6. An exhaust system
+ 7. Systems of start, ignition
+ 8. Transmissions
+ 9. Coupling, shaft
+ 10. Brake system
+ 11. A suspension bracket
+ 12. A steering
+ 13. A body
+ 14. An electric equipment





5.7. The gauge of level of fuel

Check

PERFORMANCE ORDER
1. Remove pressure in fuel system. Remove a wire of weight from the accumulator.
2. Remove the block of the index of level of fuel with fuel the pump from a fuel tank. On cars 4WD two gauges of level of fuel are established. Unscrew nuts of fastening of the gauge of level of fuel.
3. Using an ohmmeter and moving a float of the gauge of level of fuel, measure resistance of the gauge which should change from 1 to 50 Ohm.

Replacement

PERFORMANCE ORDER
1. Remove the gauge of level of fuel.
2. If the sealing lining of the gauge of level of fuel at gauge removal is damaged, replace it with the new.
3. Disconnect an internal electric socket.
4. Unscrew a bolt of fastening of the gauge of level of fuel.
5. Remove the gauge of level of fuel from a cover.
6. Installation is made in sequence, return to removal.