Subaru Legacy

Since 1990-1998 of release

Repair and car operation



Subaru Legasi
+ 1.1. Identification numbers
+ 2. Maintenance service
+ 3. Engines
+ 4. Heating, ventilation
- 5. Fuel system
   5.1. Introduction
   5.2. Technical characteristics
   5.3. Pressure removal in fuel system
   5.4. Check of the fuel pump
   5.5. The fuel pump
   5.6. A fuel separator (only models 4WD)
   5.7. The gauge of level of fuel
   5.8. A fuel tank
   5.9. A casing of the air filter
   5.10. An accelerator cable
   5.11. Electronic system of injection of fuel
   5.12. Fuel system
   5.13. System of giving of air
   5.14. Electronic control system
   5.15. Check of system of injection of fuel
   + 5.16. Check and replacement of elements of system of injection of fuel
   5.17. Турбонагнетатель
   5.18. Check of the executive mechanism заслонки турбонагнетателя
   5.19. The general check турбонагнетателя
   5.20. Removal and installation турбонагнетателя
+ 6. An exhaust system
+ 7. Systems of start, ignition
+ 8. Transmissions
+ 9. Coupling, shaft
+ 10. Brake system
+ 11. A suspension bracket
+ 12. A steering
+ 13. A body
+ 14. An electric equipment





5.9. A casing of the air filter
THE GENERAL DATA

The air filter

1 – the air filter
2 – a cover of the air filter
3 – скоба
4 – the gauge of a stream of air
5 – a filtering element of the air filter
6 – a lining
7 – a rubber support
8 – a lining
9 – a casing of the air filter
10 – an arm
11 – a sealing ring

The air filter of the engine with турбонагнетателем

1 – a lining
2 – the resonator
3 – the air filter
4 – a collar
5 – an air inlet pipe
6 – a collar
7 – a sealing ring
8 – скоба
9 – the resonator chamber
10 – a ventilating hose
11 – a collar
12 – a hose of the bypass valve
13 – a hose of the valve of ventilation картера
14 – турбонагнетатель
15 – a branch pipe
16 – air bypass the valve
17 – a hose to the inlet channel
18 – a vacuum hose of the bypass valve
19 – a hose
20 – a lining
21 – a suspension bracket of a casing of a collector
22 – a throttle
23 – the throttle gauge
24 – a lining
25 – a collector casing

PERFORMANCE ORDER
1. Remove a wire of weight from the accumulator.
2. Remove filtering element from a casing of the air filter.
3. Ослабьте a collar on a tube of an air inlet also remove it from a casing of the air filter. Remove the top half of casing of the air filter together with a measuring instrument of a stream of air and an air inlet tube (fig. the Air filter see).
4. Unscrew bolts of fastening of a casing of the air filter.
5. Remove a casing of the air filter and take it from a motor compartment.
6. Installation is made in sequence, return to removal.