Subaru Legacy

Since 1990-1998 of release

Repair and car operation



Subaru Legasi
+ 1.1. Identification numbers
+ 2. Maintenance service
+ 3. Engines
+ 4. Heating, ventilation
+ 5. Fuel system
- 6. An exhaust system
   6.1. Service of final system
   + 6.2. Reduction of toxicity of exhaust gases and management of engine work
+ 7. Systems of start, ignition
+ 8. Transmissions
+ 9. Coupling, shaft
+ 10. Brake system
+ 11. A suspension bracket
+ 12. A steering
+ 13. A body
+ 14. An electric equipment





6. An exhaust system

6.1. Service of final system
THE GENERAL DATA

Exhaust system

1 – the oxygen gauge
2 – the top casing of a pipe
3 – a lining
4 – a clip
5 – the bottom casing of the catalyst
6 – the top casing of the catalyst
7 – a lining
8 – the top casing of the left pipe
9 – a reception exhaust pipe
10 – the top casing of a back pipe
11 – a flange
12 – a lining
13 – a spring
14 – a bolt
15 – the top casing
16 – the top casing
17 – a back exhaust pipe
18 – the bottom casing
19 – a rubber suspension bracket
20 – a lining
21 – a rubber suspension bracket
22 – the muffler
23 – a tip of an exhaust pipe
24 – an arm (an automatic transmission)
25 – an arm (2WD)
26 – an arm (4WD)

Forward part of an exhaust system of cars with турбонагнетателем

1 – a lining
2 – the top casing of a final collector
3 – a final collector
4 – the bottom casing of a final collector
5 – an arm
6 – the top casing
7 – a clip
8 – the top lining
9 – the top lining
10 – a lining
11 – a forward pipe
12 – the bottom lining
13 – the bottom lining
14 – a clip
15 – the bottom casing
16 – a lining
17 – a lining
18 – the top casing of a final collector
19 – a final collector
20 – the bottom casing of a final collector

Drawing of a special liquid before рассоединением an exhaust pipe


Check of a condition of rubber pillows of the muffler

The final system consists of a final collector, the catalyst, the muffler, an exhaust pipe and other connecting pipes, arms, suspension brackets and collars. Final systems fastens to the bottom of the car by means of arms of fastening and rubber suspension brackets. If one of these details is damaged or deformed by a consequence presence of noise or the vibration transferred through the bottom of the car.

At repair of final system take advantage of following simple councils:

 – Begin work with a back part of the car and move to a forward part;
 – Put special means for fastening details to facilitate their removal;
 – At installation of details of final system put new linings, suspension brackets and collars;
 – At assemblage grease a carving of details of fastening with special structure against jamming;
 – Leave a sufficient and uniform backlash between established details and the body bottom.