Subaru Legacy

Since 1990-1998 of release

Repair and car operation



Subaru Legasi
+ 1.1. Identification numbers
+ 2. Maintenance service
+ 3. Engines
+ 4. Heating, ventilation
+ 5. Fuel system
+ 6. An exhaust system
- 7. Systems of start, ignition
   7.1. Introduction
   7.2. Technical characteristics
   7.3. Accumulator check
   7.4. Accumulator gymnastics
   7.5. The accumulator
   + 7.6. Ignition system
   - 7.7. Gymnastics system
      7.7.1. The generator
      7.7.2. Repair and generator check
   + 7.8. System of start of the engine
+ 8. Transmissions
+ 9. Coupling, shaft
+ 10. Brake system
+ 11. A suspension bracket
+ 12. A steering
+ 13. A body
+ 14. An electric equipment





7.7. Gymnastics system
THE GENERAL DATA

If the control lamp of gymnastics of the accumulator does not burn at ignition inclusion, check up connection of wires to the generator and integrity of a control lamp. If the lamp still does not burn, check up an electric chain from the generator to a lamp. If all electric chains are serviceable, means, the generator is faulty and it should be replaced or repaired.

If the control lamp of gymnastics of the accumulator burns at engine work, stop the engine and check up a condition and a tension приводного a generator belt, and also connection of wires to the generator.

Check of a regulator of pressure

PERFORMANCE ORDER
1. Connect the voltmeter to poles of the accumulator and start the engine.
2. Increase turns of the engine before stabilisation of indications of the voltmeter which should show from 12 to 13 In, but no more than 14 Century
3. Include a maximum quantity of electric consumers (a headlight, a heater of back glass, the heater fan). Thus the pressure developed by the generator with a regulator of pressure, should be in limits from 13 to 14 Century
4. If pressure does not correspond to demanded sizes, the worn out brushes of the generator, a weak spring of brushes, a faulty regulator of pressure, the faulty diode, winding breakage статора or defective contact rings of a rotor can be a cause of defect.
5. Disconnect a plait of wires from the generator and check up that on contact S and contact In there is a pressure of the accumulator.
6. Check up pressure of the accumulator on contact IG. Pressure on contact IG should appear after ignition inclusion.
7. Connect contact L to weight. Thus the control lamp of gymnastics of the accumulator should light up.