Subaru Legacy

Since 1990-1998 of release

Repair and car operation



Subaru Legasi
+ 1.1. Identification numbers
+ 2. Maintenance service
+ 3. Engines
+ 4. Heating, ventilation
+ 5. Fuel system
+ 6. An exhaust system
+ 7. Systems of start, ignition
- 8. Transmissions
   - 8.1. A mechanical transmission
      8.1.1. Introduction
      8.1.2. Technical characteristics
      8.1.3. The gear change lever
      8.1.4. Check and replacement of support of a transmission
      8.1.5. Switches of light of a backing and neutral position КП
      8.1.6. Removal and transmission installation
   + 8.2. An automatic transmission
+ 9. Coupling, shaft
+ 10. Brake system
+ 11. A suspension bracket
+ 12. A steering
+ 13. A body
+ 14. An electric equipment





8.1.3. The gear change lever
THE GENERAL DATA

Details of the lever of a gear change of models 4WD


1 – the handle of the lever of a gear change
2 – a protective cover
3 – a plate of a protective cover
4 – the gear change lever
5 – the plug
6 – an axis
7 – collars
8 – the basis
9 – a lock ring
10 – a sealing ring of round section
11 – the plug
12 – бреккер
13 – draught
14 – the hinge
15 – draught of a gear change
16 – an arm
17 – a spring
18 – the shock-absorber
19 – draught

On models 2WD the gear change lever is similar.

Removal

PERFORMANCE ORDER
1. Unscrew the handle from the gear change lever.
2. Remove the central console and a cover of the lever of a gear change.
3. Unscrew screws of fastening of a plate of a cover of the lever of a gear change and remove a plate from a car floor.
4. Lift the car and fix on supports.
5. Disconnect the forward end of draught of the shock-absorber from a transmission, having unscrewed bolts (are specified by arrows).
6. Remove a spring of draught of the shock-absorber.
7. Disconnect the forward end of draught of a gear change from a transmission.
8. Installation is made in sequence, return to removal.